slxdeveloper.com Community Forums

The Forums on slxdeveloper.com are now retired. The forum archive will remain available for the time being. Thank you for your participation on slxdeveloper.com!

Reporting & Notification Forums - Reporting
Forum to discuss reports for SalesLogix including Crystal, SQL Reports, etc. View the code of conduct for posting guidelines.

Forums RSS Feed

Back to Forum List | Back to Reporting | New Thread

View: Search:

Author

Thread: How to avoid being prompted twice for parameters?

Ken
Posts: 13

How to avoid being prompted twice for parameters? Your last visit to this thread was on 1/1/1970 12:00:00 AM

Posted: 12 Jun 09 12:28 PM

I have two date parameters in my report. When I run the report, I am prompted to enter values for these two parameters. I enter values and click OK and then I am prompted again to enter values for the same two parameters. How can I fix this?

The report uses the command feature to specify the sql. The two parameters are used in the where clause as follows:

and SPES.CreateDate between {?SPESCreateDateStart} and dateadd(day, 1, {?SPESCreateDateEnd})

This is the only place in the report where the parameters are used. The parameters are not displayed in the report and are not used in any formulas. There are no sub-reports.

I also noticed that when I checkout the report from the Architect/Manage Reports, I am prompted once for the parameters before the report shows up in the CheckOut folder.

I am using SLX 7.2 with the SLX provided version of Crystal (11.5).

[Reply][Quote]

John Gundrum
Posts: 632

Re: How to avoid being prompted twice for parameters? Your last visit to this thread was on 1/1/1970 12:00:00 AM

Posted: 15 Jun 09 10:45 AM

I've run into this same issue and haven't found any solution.

John G.

[Reply][Quote]

Maria Amodei
Posts: 24

Re: How to avoid being prompted twice for parameters? Your last visit to this thread was on 1/1/1970 12:00:00 AM

Posted: 16 Jun 09 5:10 AM

Since you have no subreports, how about using a main report that is just a holder. Put two matching parameters in the main report and pass them to the sub report parameters via linking.

Maria

[Reply][Quote]

Martin Rudnick
Posts: 52

Re: How to avoid being prompted twice for parameters? Your last visit to this thread was on 1/1/1970 12:00:00 AM

Posted: 23 Jun 09 4:59 PM

Is there any When Open action tied to the report in the Execution tab of the edit properties of the report in Architect?

[Reply][Quote]

Ken
Posts: 13

Re: How to avoid being prompted twice for parameters? Your last visit to this thread was on 1/1/1970 12:00:00 AM

Posted: 24 Jun 09 1:19 PM

There is no When Open action tied to this report.

[Reply][Quote]

Page 1 of 1

You can subscribe to receive a daily forum digest in your user profile. View the site code of conduct for posting guidelines.

Forum RSS Feed - Subscribe to the forum RSS feed to keep on top of the latest forum activity!

slxdeveloper.com is brought to you courtesy of Ryan Farley & Customer FX Corporation. This site, and all contents herein, are Copyright © 2024 Customer FX Corporation. The information and opinions expressed here are not endorsed by Sage Software.	code of conduct \|

page cache (param): 11/25/2024 6:39:08 AM